Skip to navigation

How To Use the Glue Stick on your Mark One Print Bed

Preparing The Print Bed

You must use the glue stick, or you risk damaging your print head, reduce the likelyhood of a successful print and make it harder to release the print when the build is complete.Video Player

Use the supplied glue stick to apply a thin layer of glue to the print bed. It’s water-soluble kids glue.

You can apply glue to the entire bed, or just where the part prints.If you apply a thin layer of glue, you can apply it before each print.If you notice glue buildup (an uneven, pitted looking surface) wash the residual glue from the bed with warm water and dry with a paper towel.The bed is waterproof. You can fully submerge the bed, and wash it thoroughly. Do not use a dishwasher.

Note

Do not use soaps or other cleaners, as these may damage or leave residue on the bed

Before starting a print, ensure that the print bed is totally clean of plastic from any previous prints. Scrape off any plastic with the bed provided bed scraper.You can use warm water to wash old glue off the bed – avoid soap, it can damage the finish

Quick Tip

Use the provided glue stick to apply a thin layer of glue to the print bed where you intend to print. This will keep the part attached to the bed.

All of the blogs and the information contained within those blogs are copyright by Markforged, Inc. and may not be copied, modified, or adopted in any way without our written permission. Our blogs may contain our service marks or trademarks, as well as of those our affiliates. Your use of our blogs does not constitute any right or license for you to use our service marks or trademarks without our prior permission. Markforged Information provided in our blogs should not be considered professional advice. We are under no obligation to update or revise blogs based on new information, subsequent events, or otherwise.

Never miss an article

Subscribe to get new Markforged content in your inbox